PlyEdit: Dirt

Often realism in computer graphics can be greatly enhanced by adding imperfections to color textures. These naturally occurring features, a result of an object's exposure to the physical environment, can include rain staining, scratches, scarring, bleaching, corrosion and the accumulation of dirt.

With the Dirt tool you can automatically calculate the later; dirt (black) is added to the polymesh color in crevices (see right side of Fig 1).

Fig 2. Dirt

The Dirt tool (see Fig 2) has three main parameters that control the dirt calculation process:

Radius: One way to think of this is to cover your object completely with dirt, then get a felt covered ball of the defined Radius and rub it over the surface. If the ball is large, large areas of the polymesh will stay dirty because the felt won't be able to reach them. But if the ball is small, then only narrow crevices will retain dirt.

As the Radius increases, so too does the calculation time.

Grain: This controls the accuracy vs. speed of the dirt calculations. As you increase the Grain percentage, the speed increases but the accuracy drops. Reasonable values here are between 5% and 50%.

If the Grain is very low there's a chance that the whole object gets colored black. This is a bug; increase the Grain until the problem disappears.

Smooth: Increase the Smooth amount to blur the final result.

Retrieved from "http://www.headus.com/doc/PlyEdit:_Dirt"

 Often realism in computer graphics can be greatly enhanced by adding imperfections to color textures. These naturally occurring features, a result of an object's exposure to the physical environment, can include rain staining, scratches, scarring, bleaching, corrosion and the accumulation of dirt.
-With the Dirt tool you can automatically calculate the later; dirt (black) is added to the polymesh color in crevices (see right side of {{fig}}).
+With the Dirt tool you can automatically calculate the later; dirt (black) is added to the polymesh color in crevices (see right side of {{fig}}). {{img|PlyEdit-dirt1.png|Dirt}}
-{{img|PlyEdit-dirt1.png|Dirt}}
+The Dirt tool (see {{fig}}) has three main parameters that control the dirt calculation process:
+; Radius : One way to think of this is to cover your object completely with dirt, then get a felt covered ball of the defined Radius and rub it over the surface. If the ball is large, large areas of the polymesh will stay dirty because the felt won't be able to reach them. But if the ball is small, then only narrow crevices will retain dirt.
+: As the Radius increases, so too does the calculation time.
+; Grain : This controls the accuracy vs. speed of the dirt calculations. As you increase the Grain percentage, the speed increases but the accuracy drops. Reasonable values here are between 5% and 50%.
+: If the Grain is very low there's a chance that the whole object gets colored black. This is a bug; increase the Grain until the problem disappears.
+; Smooth : Increase the Smooth amount to blur the final result.