PlyEdit: F - Filling
From Headus Docs
(Difference between revisions)
| Revision as of 06:36, 12 November 2007 (edit) Headus (Talk | contribs) ← Previous diff |
Revision as of 06:36, 12 November 2007 (edit) (undo) Headus (Talk | contribs) Next diff → |
||
| Line 4: | Line 4: | ||
| Figure 1 | Figure 1 | ||
| shows you what you get once you have hit the {{key|F}} | shows you what you get once you have hit the {{key|F}} | ||
| - | key; a menu of further key commands down the bottom of the screen. | + | key; a count of the number of visible holes, followed by a menu of further key commands down the bottom of the screen. |
| [[Image:PlyEdit-fill2.png|right|thumb|Figure 2. Filling A Hole]] | [[Image:PlyEdit-fill2.png|right|thumb|Figure 2. Filling A Hole]] | ||
Revision as of 06:36, 12 November 2007
|
Holes in the mesh are outlined in blue. There are a hand-full of hole filling operations, all accessed via the <F> key.
 Figure 1. Filling Menu Figure 1 shows you what you get once you have hit the <F> key; a count of the number of visible holes, followed by a menu of further key commands down the bottom of the screen.  Figure 2. Filling A Hole |