PlyEdit: 3 - Noise

The Noise tool does the opposite of smoothing. Normally 3D scans have a bit of noise in them, but filled holes are perfectly smooth, so the noise brush can be used to make the filled areas look more like real data.

Fig 1 shows you what you get when you use the <3> key; there's only two options:

<3> - Painting

Press and hold the <3> key to apply noise at the mouse pointer location. You can adjust the degree of noisiness under the Brushes panel.

<G> - Noise Marked Area

Or you can use the <G> key to mark an area out first, then use <3><G> to apply noise to that area.

Retrieved from "http://www.headus.com/doc/PlyEdit:_3_-_Noise"

 ==== {{key|3}} - Painting ====
-Press and hold the {{key|3}} key to apply noise at the mouse pointer location. You can adjust the degree of noisiness of the noise brush under the '''Brushes''' panel.
+Press and hold the {{key|3}} key to apply noise at the mouse pointer location. You can adjust the degree of noisiness under the '''Brushes''' panel.
 ==== {{key|G}} - Noise Marked Area ====
 Or you can use the {{key|G}} key to mark an area out first, then use {{key2|3|G}} to apply noise to that area.