headus 3D tools headus 3D tools / 3D scans
Support Forums
 
 FAQFAQ   SearchSearch    UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
headus 3D scans

Purple Lines

 
Post new topic   Reply to topic     headus 3D tools -> UVLayout -> Questions and Answers
View previous topic :: View next topic  
Author Message
axia777



Posts: 15
Joined: 20 Aug 2007
PostPosted: Thu Aug 30, 2007 9:30 pm    Post subject: Purple Lines Reply with quote
When I have an inside edge that has no splits in it the edge has a purple line on it. What does this signify? Is it bad? Good? Just wondering if anyone knows.
Back to top
View user's profile Send private message
headus
Site Admin


Posts: 2902
Joined: 24 Mar 2005
Location: Perth, Australia
PostPosted: Thu Aug 30, 2007 9:41 pm    Post subject: Reply with quote
Its probably a webbing loop. These are automatically applied to holes when you use the Shift-F hotkey on an unflattened piece of mesh. It helps to keep the hole open, otherwise the surrounding polys can sometimes push in and collapse the hole. You can remove and add these by hand with Shift-T on one of the edges. Its covered in the UVLayout-Beta-v1.12.mov video.

Phil
Back to top
View user's profile Send private message Send e-mail Visit poster's website
axia777



Posts: 15
Joined: 20 Aug 2007
PostPosted: Thu Aug 30, 2007 9:58 pm    Post subject: Reply with quote
Thank you Phil.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic     headus 3D tools -> UVLayout -> Questions and Answers All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group