headus 3D tools

sunfun · Posts: 11 Joined: 31 Jul 2007

thank you.I have sent a Either ID to you ,wait for your keys.

sunfun · Posts: 11 Joined: 31 Jul 2007

I have a new tested,it is ok now,only it can not save the outline option is a little pity,can we use this command like : auto dxf -outline to XXX.cmd ,so i can contral it freely.

thanks you .

ps. i live in china and I have credit card that can pay for with US$ ,but is not kind of VISA,Master ...how can I do?

headus · Posted: Sat Aug 04, 2007 6:35 pm Post subject:

"only it can not save the outline option"

OK, I'll get it to remember that setting for the next release. I'm out of the office for the first half of this week, so it wont be until the end of the week.

Regarding payment, there's PayPal buttons on the Buy page; you don't have to have a paypal account to use their payment service, and they may accept your card.

Phil

sunfun · Posts: 11 Joined: 31 Jul 2007

dear:
I have payed 175$ via visa credit ,pls check it .

and I wait for the newest release that can save the setting and it can hide it's GUI if I want ,ok?

can you give me your email,I want some cooperations with you,so have some detail contact to you.

thanks.

headus · Posted: Sun Aug 12, 2007 10:06 pm Post subject:

Thanks for buying UVLayout! Yes, the payment has coming through, we just have to wait now for it to be fully checked/cleared which usually happens within 24hours.

I should be able to release a new install later today which will let you to permanently set the Outline setting for the DXF and EPS exports.

My email address is architec@headus.com.au.

Phil

headus · Posted: Sun Aug 12, 2007 10:21 pm Post subject:

Actually, your payment just got cleared. I'll set up your account and generate the permanent license in a few minutes.

Phil

headus · Posted: Mon Aug 13, 2007 12:53 am Post subject:

UVLayout v.1.21.1 in now available from uvlayout.com/try, and this release remembers the "Outline" setting for the DXF and EPS exports.

Phil

sunfun · Posts: 11 Joined: 31 Jul 2007

thanks for all works for me ,but I don't want to dispaly the gui when it works as plugin mode ,just need it's function,I have tried some methods ,can't hide the GUI ,can you help me ?

ps: there is a little bug when it flatern over , the drawing is not fit to windows ,then it is very large zoom ,please fix it ,thank you .

headus · Posted: Mon Aug 13, 2007 9:11 pm Post subject:

"the drawing is not fit to windows "

Fixed.

"but I don't want to dispaly the gui when it works as plugin mode"

I think I can possibly minimize the GUI window automatically, but aren't sure
I want to hide the fact that UVLayout is being used in your flattening pipeline.
Are you developing a commercial application? You can email me if you don't
want to reveal details of your project here.

Phil