Support:Parallax
From Headus Docs
Contents |
Defining Panels Geometry
Panels Parameters
-panels,<quality>,<width>,<height>,<depth>,<base>,<scale>
quality : render quality, 1 lowest, 3 good, 6 max width : of display panel in mm height : of display panel in mm depth : distance between front and back panels base : offset of panels from ground plane scale : scale panels up or down to suit mesh size
Default settings:
-panels,3,296,475,401,375,2
Defining Panoramic Background
Pano Parameters
-pano,<spin>,<min>,<max>,<file> spin : spin dome around in degrees min : done starts here in degrees max : done ends here in degrees file : filename of 360 panoramic photo
Externally Driven Viewpoint
On plyview command line:
-driven,<file.txt>
Then write values into the named text file from other application, adding a second line for secondary viewer:
<inclination-degrees> <azimuth-degrees> <distance-mm> <object-spin-degrees> <inclination-degrees> <azimuth-degrees> <distance-mm>
If there's no second line, a standard (non-parallaxed) view is assigned to the non-facing panels.
For example:
120.4 10.2 3232.4 77.4
 | I think distance here would be in the original object scale, so if the panels to object relative scales have been adjusted (see above) then this distance could possibly need to be adjusted. For example, if the panels scaling factor is "2", then multiply the real eye distance by that factor for use in the driven file. |
Forcing Next Pose
Write next pose number into a file called blend_next.txt. File will be deleted when that pose becomes active, so driving application can look for that if required. If no new blend_next.txt file is created, viewer reverts to random pose selection.