headus 3D tools

[catpower]

I drop my shell and hit Shift+F to do a Bloat, then it says "Hold Space to Release Boundary" - I hold the spacebar and it releases the boundaries. Then it says "Hold Space to Stop". I hold the spacebar and it says "Release to Continue". I release the spacebar (what else am I going to do hold it forever?) and it goes BACK TO BLOAT!
I'm stuck in an infinite bloating-flattening loop. I've had the same problem on 2 computers so obviously I'm missing something. What am I supposed to do and if I'm supposed to do something else why does it tell me to hold the spacebar?

Thanks - Chris

[headus]

Yikes, bug confirmed! I can get it to do exactly the same thing if Shift-F is held for too long ... it dumps a whole lot of Shift-F's into the input queue, and so once the first bloat is finished, it starts again. Eventually (after hitting space lots of times) it eats up the remaining Shift-F's and stops bloating.

I'll get it to flush the input queue once its finished the first bloat. I hope to upload a new release sometime in the next few days, but in the meantime, tap that Shift-F quickly and you should be OK.

Phil

[catpower]

Makes sense, sometimes it would loop sometimes it wouldn't, so just tap Shift+F don't hold it.
Thanks a lot - Chris