headus 3D tools

[CoreX]

hello everybody,

i´m testing at tis time UVLayout and i thing it is an exellent tool!!
I have a problem with understanding to make cuttings on the right place.
i want unfold a paw. But i don´t know where I should start cutting.

I hope anyone can help. Thx!!

PS:Sorry for my bad english!

[headus]

I'd start off by cutting the bottom off, then split the remainder up the back or inside (see green line in attached image). Flatten those out, then you could weld them back together along one side (red dots in image).

As always, there's more than one way to do these things, but that'll give you the least distorted result.

Phil

[CoreX]

Thank you!! I will try it!