headus 3D tools headus 3D tools / 3D scans
Support Forums
 
 FAQFAQ   SearchSearch    UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
headus 3D scans

How do I enable C/W on Blue Seam?

 
Post new topic   Reply to topic     headus 3D tools -> UVLayout -> Questions and Answers
View previous topic :: View next topic  
Author Message
jaw312



Posts: 14
Joined: 03 Oct 2006
PostPosted: Tue Oct 03, 2006 9:37 pm    Post subject: How do I enable C/W on Blue Seam? Reply with quote
My obj comes in with a blue seam right down the center (from mirroring geom).
But I can't use C or W or anything on this line.
How do I "un-Blue" it?

Thanks
--
jaw
Back to top
View user's profile Send private message
headus
Site Admin


Posts: 2902
Joined: 24 Mar 2005
Location: Perth, Australia
PostPosted: Tue Oct 03, 2006 10:24 pm    Post subject: Re: How do I enable C/W on Blue Seam? Reply with quote
jaw312 wrote:
How do I "un-Blue" it?

The blue edges indicate a hole or seam in the geometry, and UVLayout tries very hard not to touch the geometry at all, its just for editing UVs. If you need to fill in a hole, or weld a seam in the geometry, then that currently has to be done externally, usually in whatever application you used to create the geometry in the fist place.

Phil
Back to top
View user's profile Send private message Send e-mail Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic     headus 3D tools -> UVLayout -> Questions and Answers All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group