headus 3D tools headus 3D tools / 3D scans
Support Forums
 
 FAQFAQ   SearchSearch    UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
headus 3D scans

Request regarding marking edges for straightening

 
Post new topic   Reply to topic     headus 3D tools -> UVLayout -> Updates, Comments, Requests
View previous topic :: View next topic  
Author Message
Optagon



Posts: 6
Joined: 06 Apr 2017
PostPosted: Mon Sep 23, 2019 12:03 pm    Post subject: Request regarding marking edges for straightening Reply with quote
Pressing i over edges to mark them for being horizontal/vertical is one of my favorite features with this program. But I don't like that I can't mark one edge at the time, but it insists on marking about 10 edges along the loop. That means I always have to mark an edge, and then go deselect the 9 I don't want with backspack every time.

Can the hotkey please be changed to just mark single edges? Alternatively it could work just like the cut tool where it designates the entire loop but the edge I marked acts as a stop, and backspace works just like weld does so I can deselect the entire loop up until the one I manually marked.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic     headus 3D tools -> UVLayout -> Updates, Comments, Requests All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group