headus 3D tools

mokosan · Posts: 150 Joined: 03 Apr 2006 Location: NZ

Im experiencing some crashes with the latest beta v2.06.03.

I cant recall what the dialog box says but it is a new crash.
Is there a log file I can send you?

M

mokosan · Posts: 150 Joined: 03 Apr 2006 Location: NZ

Unknown fatal error detected. Exciting!

headus · Posted: Wed Feb 24, 2010 5:39 pm Post subject:

Do you remember what you were doing (or had just done) when it crashed?

I did fix a fatal error crash yesterday, but I think it was for something I'd added a few days ago, so the bug wouldn't have been in the latest windows version upload.

Phil

mokosan · Posts: 150 Joined: 03 Apr 2006 Location: NZ

I dont remember exactly what I was doing, except that it wasnt anything particularly advanced. I'll try to remember next time.

mokosan · Posts: 150 Joined: 03 Apr 2006 Location: NZ

Ok it happened again, I was trying to cut some edges. I think I was accidently pressing shift-v, then went to shift-c, then it crashes. pic

M

headus · Posted: Thu Feb 25, 2010 11:55 pm Post subject:

Ahhh, its the Shift-V! Its put those anchor points everywhere, and I suspect has caused the fatal error also. Its a debug thing I use for other stuff, but has slipped through the net into the released version.

I've just fixed that, and will build and upload a new installer shortly.

This upload will also add the ability to detach and weld with Enter as you normally would when in fast weld mode. If no fast weld edge is selected then it falls through to the normal Enter key actions.

Phil

headus · Posted: Fri Feb 26, 2010 12:56 am Post subject:

New installer has been uploaded to the Extras page.

Phil