headus 3D tools

[guarie]

This is probably been answered elsewhere - so apologies in advance.

I have a necklace I am mapping that is made up of alternate spheres and cylinders. How do I map one cylinder and one sphere and then apply it to the remaining ones.

I do have UvLayout Pro.

Thanks

Paul

PS example shown below (this is not the real thing - just a quick dummy to explain the model better).

[headus]

"How do I map one cylinder and one sphere and then apply it to the remaining ones."

You'll need UVLayout v2.01, which added the "Copy UVs" tool. Have a look at the two "Copy UVs" videos under the "Advanced" section of the videos; I cant remember which one it was in, but it shows the UVs from one wheel on a tank being copied to all the other wheels.

http://www.uvlayout.com/videos

Phil

[guarie]

That worked a treat Phil! Thanks a lot for the nudge in the right direction.

Paul