CySize: Hotkeys

From Headus Docs

(Difference between revisions)

Jump to: navigation, search

Current revision

Hotkeys

<I> - Show Measurement Info: Move the mouse pointer over a point, curve or section guide curve, and tap the <I> key to display its measurements in a list at the top left of the display window.

<[/]> - Step Section Position: With the mouse pointer over a section guide curve, use the <[> and <]> keys to step the cutting plane back and forth along the curve. Use <Shift-[> and <Shift-]> to step by larger increments.

</> - Set Section Position: Hold down the </> key and move the mouse pointer along a section guide curve to position the cutting plane interactively.

<|> - Find Section Min/Max: Use the <|> key on a section guide curve to position the cutting plane at the point of maximum circumference. Use <|> again to then search for the minimum circumference position.

<=/-> - Increase/Reduce Section Distance

<V> - Toggle Volume: Use <V> to toggle a section as a volume divider, or to toggle a point as a volume seed.

<T> - Toggle Tape Measure: Use <T> on a curve or section to toggle between over-surface and tape measure lengths.

<R> - Toggle Planar Section

<B> - Toggle Bounding Section: Use <B> on a section guide curve to toggle on and off the calculation of the bounding outline.

Fig 1. Bounding Outline

<J> - Join/Split Curves

Retrieved from "http://www.headus.com/doc/CySize:_Hotkeys"

 {{:CySize: Menu}}
+; {{key|I}} - Show Measurement Info : Move the mouse pointer over a point, curve or section guide curve, and tap the {{key|I}} key to display its measurements in a list at the top left of the display window.
+; {{key|[/]}} - Step Section Position : With the mouse pointer over a section guide curve, use the {{key|[}} and {{key|]}} keys to step the cutting plane back and forth along the curve. Use {{key|Shift-[}} and {{key|Shift-]}} to step by larger increments.
+; {{key|/}} - Set Section Position : Hold down the {{key|/}} key and move the mouse pointer along a section guide curve to position the cutting plane interactively.
+; '''<|>''' - Find Section Min/Max : Use the '''<|>''' key on a section guide curve to position the cutting plane at the point of maximum circumference. Use '''<|>''' again to then search for the minimum circumference position.
+; '''<=/->''' - Increase/Reduce Section Distance :
+; {{key|V}} - Toggle Volume : Use {{key|V}} to toggle a section as a volume divider, or to toggle a point as a volume seed.
+; {{key|T}} - Toggle Tape Measure : Use {{key|T}} on a curve or section to toggle between over-surface and tape measure lengths.
+; {{key|R}} - Toggle Planar Section :
+<table><tr><td valign=top>
+; {{key|B}} - Toggle Bounding Section :  Use {{key|B}} on a section guide curve to toggle on and off the calculation of the bounding outline.</td><td>{{img|CySize-bounding.jpg|Bounding Outline}}</td></tr></table>
+; {{key|J}} - Join/Split Curves :